Page 1 of 1

Configuring the PostQressl database

PostPosted: Thu Nov 24, 2011 9:47 am
by IAdjust2U
Hi all!

I`m pretty new to pokertracker, i bought it and followed the instructions until i came to the creating of a new database section.
How long does this take? Is it common that it get`s freezed? Im looking at a box in the lower left corner that says configuring
the postqressl database, but nothing happens.

Looking forward to hear if it someone who have a solution.

Re: Configuring the PostQressl database

PostPosted: Thu Nov 24, 2011 10:48 am
by WhiteRider
It shouldn't take more than a few seconds.
Try ending the PT3 process and run it again. If you still have problems...

What operating system do you have?

When you first ran PT3 did it install PostgreSQL for you?

Do you see PostgreSQL on your computer? Click Start and type "services" and click on it when it appears. Do you see PostgreSQL in the list? Can you start it?

If you already had PostgreSQL installed on your computer then you will need to use the password it was set up with - if you tried another tracker try "postgrespass" for instance.